The
8630C accelerometers meet requirements for modal analysis.
The light weight, five gram design reduces mass loading
on light structures, especially when multiple units are
used. This sensor feature high sensitivity and high thermal
rejection. Type 8630 accelerometers are housed in a hard
anodized, environmentally sealed housing. The finish provides
ground isolation as well as environmental protection.
Type 8636C is designed for stud mounting. The patented
PiezoBEAM design features outstanding phase reponse as
well as a wide frequency range. The sensor is available
in three ranges with sensitivities as high as 1000mV/g.
The built-in
charge amplifier provides a low impedance voltage output, allowing use of low cost, standard cabling. These sensors will
operate directly from the internal power source, available in most FFT analyzers or from Kistler's large selection of
power supply couplers. The sensor can be connected with a common coaxial cable such as Type 1761B.
• Low impedance, voltage mode
• High sensitivity
• Very low noise, dynamic range >90dB
• Small transverse sensitivity
• Ground isolated
• Conforming to CE
The
8630C accelerometers meet requirements for modal analysis.
The light weight, five gram design reduces mass loading
on light structures, especially when multiple units are
used. This sensor feature high sensitivity and high thermal
rejection. Type 8630 accelerometers are housed in a hard
anodized, environmentally sealed housing. The finish provides
ground isolation as well as environmental protection.
Type 8636C is designed for stud mounting. The patented
PiezoBEAM design features outstanding phase reponse as
well as a wide frequency range. The sensor is available
in three ranges with sensitivities as high as 1000mV/g.
